Acceptance and commissioning should be performed after initial setup is complete. The addition of Primary Protectors is not sufficient protection in order to connect these interfaces metallically to OSP wiring. This document contains information that is proprietary mqnual Ceragon Networks Ltd. Where possible, the pole should be away from the edge of the building. Pour isoler compltement l’unit, il faut dbrancher toutes les alimentations lectriques.! A pole that is not perpendicular may cause problems during antenna alignment.
Upon completing the Commissioning Log, send the log to Ceragon support center at support ceragon. Ceragon IP-10 IDU CLI Commands Listīy continuing to use this website, you agree to their use. Run BER stability test on the link for at least 15 minutes to ensure error-free operation. Statement of Conditions The information contained in this document is subject to change without notice. Insert four screws and washers provided with the kit, and tighten manuak. Verify no Ethernet traffic cables or fibers connected. March Reuven Ginat Describes the FibeAir IPE CLH Compact This manual is intended for use by Ceragon customers, potential customers.
Introducing FibeAir IP FibeAir IP is Ceragon’s next. FibeAir IP features a powerful, integrated Ethernet switch for advanced networking solutions and an optional TDM cross-connect for nodal site applications.
